ADJUSTMENT

 

1. The parts of name  

2. How to set up 
a). Adjustment of “HIMO”

Pull “HIMO” up forward to vertical as slowly and it’s to do till your favorite when you put on your bear foot.

b). Adjustment of “HANAO”

Pull and turn to the out side for 45 degree Angle at the end of “HANAO” (at heel side / both right & left).

 
3. Adjustment for fit the length of “HIMO” and “HANAO”

If you still feel tight around the part of “HIMO”, you can adjust it to open the tub of Rubber Outsole. However please be carefully about this adjustment, cause “HIMO” and “HANAO” will be extend little by little during every use. So, we recommend that if you adjust for them, please try to use short walking KAKKOs after a couple of times. Although, off  course you can adjust for them before first use KAKKOs when it’s too tight your bear foot.

a). Adjustment of “HIMO”

Pull the stapler off by some needles. Then open the tub of Rubber Outsole and pull out “HIMO”. Untie the knot of “HIMO”. Then make a knot to tie your favorite placing. After that, close the tub of Rubber Outsole. Do not forget dunk the stapler again. 

b). Adjustment of “HANAO”

Pull the Rope (at heel side) up from the Dai (body) on the sole by a longnose plier. Then, untie the Rope until at the end of spiral coiled position ended. You should be better to wrap at the end of the Rope by some like cellophane tape in this time. And you tie the Rope your favorite placing. After that, you make the Rope spiral coiled again and tie. Do not forget to tie certainly.